Makita BTW104, BTW074 dimensions Assemble F/R change lever as drawn in Fig

P 6/ 15

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-2. Armature (cont.)

ASSEMBLING

(3)Assemble Motor section (Armature, Yoke unit ), Internal gear case and Brush holder to Housing set (L) as drawn in Fig. 8.

Fig. 8

Housing Set (L)

The flat surface of Brush holder complete has to be mounted perpendicularly.

	Rib	Yoke unit
90°		Mark
	The edge of Yoke unit
	has to be set inside of
	the rib.

The marking on Yoke unit should be facing upward.

(4)Mount Pig tails and Spacers as drawn in Fig. 9.

Fig. 9

1.Spacer has to be set inside the housing wall.

projection Spacer

2.Aligning this groove with

the projection of Brush holder, push Spacer toward Armature until it stops.

Pig tails

	Note: Make sure that the loosening of
	Pig tail is within 9 mm from
9mm	the edge of Brush holder.

(5)Assemble F/R change lever as drawn in Fig. 10.

Fig. 10

1.Set F/R change lever to Switch with aligning the prong portion with the projection.

2.Assemble Switch with F/R change lever to Housing set (L).

Projection of Switch

Prong portion of F/R change lever

(6)Be sure to assemble ID plate and Cover complete or Switch plate complete to Housing set (L) in accordance with

[3]-1. Note for Assembly/Disassembly and the drawings in Fig. 2. And then, assemble Housing set (R).