P 12/ 15
Wiring diagram
| BTW073, BTW103 |
Fig. | (without Automatic Impact Stop System) |
| |
| Wiring of LED Lead Wire (before setting Switch) |
Route Lead wires (black, red) between |
|
Rib A and the inner wall of Housing set (L). | LED |
|
Route lead wires (black, red) between Rib A |
|
| |
and Rib B so that they are not pinched |
|
| |
with Switch. |
| Rib A | |
Route Lead wires (black, red) between Rib B |
| ||
|
| ||
and the inner wall of Housing set (L). | Rib C | Rib B | |
| |||
If Connectors are put in Connector box A, route | |||
| |||
Lead wires (black, red) through Connector box A | Rib D | ||
and secure them with Lead wire holder A . |
|
| |
|
| Lead wire holder A | |
Connectors in Connector Box A |
| ||
Connectors in
Connector box B
Lead wire |
holder B |
Connectors can be also routed through Connector box B.
In this case, Lead wires have to be secured with Lead wire holder B.
Wiring in Housing set (L) (after setting Switch)
Be careful not to route
any Lead wires on this Rib.
Rib E 
Rib F
LED
Line filter | Switch | |
Place Line filter between Rib E and Rib F. | ||
|
Note for Wiring:
If Line filter interferes with Housing set (R) in assembling, check that Insulated terminal is tilted enough to save the space for Line filter referring to Fig.
Route Lead wires connected to Switch between Boss and the inner wall of Housing set (L).
Boss |