Ryobi C2600 warranty Unpacking and Loose Parts, Product Specifications, Loose Parts List

UNPACKING AND LOOSE PARTS

Your abrasive cut-off machine has been shipped completely assembled.

■Remove all loose parts from the carton.

■Remove the packing materials from around your machine.

■Carefully lift the cut-off machine from the carton and place it on a level work surface. This is a heavy tool. To avoid back injury, get help when needed.

■Do not discard the packing materials until you have care- fully inspected the machine, identified all loose parts, and satisfactorily operated your new abrasive cut-off machine.

■Your cut-off machine has been shipped with the machine arm locked in the down position. To release the arm, push down on top of the machine arm and pull the arm lock lever. See Figure 3.

■Hand pressure should remain on the machine arm to pre- vent sudden rise upon release of the arm lock lever.

■Examine all parts to make sure no breakage or damage has occurred during shipping.

If any parts are damaged or missing, do not attempt to plug in the power cord and turn the switch on until the damaged or missing parts are obtained and are installed correctly. Contact your nearest Ryobi dealer or call 1-800-525-2579 in the United States or 1-800-265-6778 in Canada for assistance if any parts are missing or damaged.

WARNING:

If any parts are missing do not operate your cut-off machine until the missing parts are replaced. Failure to do so could result in possible serious injury.

LOOSE PARTS LIST

The following items are included with your C2600 Abrasive Cut-off Machine:

■14 in. (356 mm) – Abrasive Wheel – Installed on Machine

■Wheel Wrench – 8 mm Hex Key – Stored on Machine

■Operator's Manual

■Warranty Registration

PRODUCT SPECIFICATIONS

Wheel Type	Reinforced Abrasive Wheels
Wheel Diameter	14 in. (356 mm)
Wheel Thickness	1/8 in. (32 mm)
Wheel Arbor Hole	1.0 in. (254 mm)
Overall Wheel Size	14 in. x 1/8 in. x 1 in.
	356 mm x 32 mm x 254 mm
No Load Speed	3300 RPM
Rating	120 Volts, 60 Hz-AC Only
Input	15 Amp
Net Weight	65 lbs. (30 kg.)

Fence Angle
Right	45°
Left	0°
Vise Clamp Angle
Right or Left	45°
Maximum Cutting Capacities:
Round Pipe	5 in. (127 mm) outside diameter
Angle Stock	6-1/2 in. wide x 3-5/16 in. tall
	165 mm wide x 84 mm tall
Flat Metal Stock	8-1/16 in. wide x 2-5/16 in. tall
	205 mm wide x 59 mm tall

WARNING:

This cut-off machine has been designed for cutting metals, using reinforced abrasive cut-off wheels only. Do not remove the wheel, install a steel blade, and attempt to cut other types of materials such as wood, masonry, etc. Attempting to cut these other types of materials could cause an accident resulting in possible serious personal injury.

WARNING:

Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a harzardous condition leading to possible serious personal injury.

Page 7