Makita 6901DW instruction manual

Page 6

Installing or removing battery cartridge

.Always switch off the tool before insertion or removal of the battery cartridge.

*To remove the battery cartridge, pull out the set plate and grasp both sides of the cartridge while withdrawing it from the tool.

0 To install the battery cartridge, insert the battery cartridge into the housing and snap the set plate back into place. Be sure to close the set plate fully before using the tool.

Charging

Plug the fast charger into your power

source. Insert the battery cartridge so thatbutton the plus and minus terminals on the bat-

tery cartridge are on the same sides as their respective markings on the fast charger. Insert the cartridge fully into the port so that it rests on the charger port floor.

Press the start button (red). The charging light will come on and charging will begin. If the charging light does not come on, press the reset button (yellow) first, then

the start button (red). If the charging light goes out within 10 seconds even after press- ing the reset button and start button a couple of times, the battery cartridge is dead. (CAUTION : Wait for more than 5 seconds after the charging light goes out to press the reset button again.) Replace it with a new one. When the charging light goes out after about one hour, you may remove the fully charged battery cartridge.

After charging, unplug the charger from the power source.

CAUTION:

0 Your new battery cartridge is not charged. You will need to charge it before use.

.Do not keep the button pressed in with tape, etc. or the circuit will not function pro- perly. Also, a malfunction of the charger may result possibly causing overheating, etc.

0 If you try to charge a cartridge from a just-operatedtool, sometimes the charging light will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it and try to charge it once more.

When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it almost completely a couple of times.

0 If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the fast charger.

6

Image 6
Contents Cordless Impact Driver Safety Instructions Page Important Safety Instructions Additional Safety Rules For Charger & Battery Cartridge Page Installing or removing driver bit 500 Page Maintenance Accessories Cordless Impact Driver Model 6901D Description Makita Limitedone Year Warranty