Installing or removing driver bit

CAUTION :

Always be sure that the tool is switched off and the battery cartridge i s removed before installing or removing the bit.

Slide the sleeve toward the motor and in- sert the bit into the sleeve as far as it will go. Then release the sleeve to secure the bit.

To remove the bit, slide the sleeve toward the motor and pull the bit out firmly.

NOTE :

If the bit is not inserted deep enough into the sleeve, the sleeve will not return to i t s original position and the bit will not be secured. In this case, try re-inserting the bit according to the instructions above.

CAUTION:

Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.

Reversing switch action

This tool has a reversing switch to change the direction of rotation. Slide the revers- ing switch to the right for clockwise rota- tion or to the left for counterclockwise.

CAUTION :

0 Always check the direction of rotation before operation.

*Use the reversing switch only when the tool comes to a complete stop. Changing the direction of rotation before the tool stops may ruin the tool.