For Husqvarna Parts Call 606-678-9623 or 606-561-4983
7.51Remove Chute Assembly for servicing other items
7.61Remove Auger Assembly for servicing
SPRING
NUT AND
WASHER
DEFLECTOR
CABLE
1) Remove spring that attaches from the deflector to the pivot.
NOTE: If unit is not equipped with a remote deflector proceed to step 4
2)Remove the nut and washer that secures the deflector cable to the deflector.
3)Remove the nut, washer and bracket that secure the cable to the chute.
CABLE
ASSEMBLY
9/16" LOCKNUT
1)Remove spark plug wire from plug.
2)Remove Deflector Chute (Section 7.51 Chute Removal)
3)Remove both 3/8" screws that secure belt cover. Remove belt cover.
RIGHT SCREW
4)Place a chair or saw horse behind handle assembly for support after auger section is split.
RIGHT BOLT | LEFT BOLT |
5)Remove both 9/16" hex bolts that hold the powerhead and auger housing together.
4)Remove the 9/16" locknut and separate the cable assembly from the chute assembly.
The chute assembly will separate, be careful not to drop the chute onto the snowthrower.
5)Reverse process to reinstall chute deflector.
To Reinstall:
7)Place belt on auger pulley and use to lift auger assembly into position so that slotted bracket on auger housing are placed onto the rod at base of powerhead.
9) Route auger belt around pulleys/guide. Check that belt is not caught on idler brkt.
10)Reinstall bolts to secure auger housing to the powerhead and belt cover.
4311)Reinstall the chute assembly and plug wire.
www.mymowerparts.com
