For Husqvarna Parts Call
Section 7.16: Replace Chute Rotator Cable | Section 7.17: Replace Chute Deflector Control |
1)Remove control panel (see section 7.11 above, for Control Panel removal instructions)
CHUTE ROTATOR
CONTROL LEVER
SCREWS
2)Remove both 5/16" screws holding rotator control to handle assembly.
SPRING
CABLE ASSEMBLY
ROTATOR HEAD
9/16" NUT
CABLE ASSEMBLY
ROTATOR HEAD
3)Remove spring from deflector, if applicable.
4)Remove 9/16" nut holding control rotator head to tubular support, and remove cable assembly from the chute. The chute will not be retained at the top, DO NOT drop chute.
5)Cut all cable ties noting locations, and paying attention to the routing of cable particularly at the lower handle.
6)Reverse process to install new cable. Install new plastic ties to hold cables.
1) Remove control panel (see section 7.11).
SPRING
NUT AND
WASHER 
DEFLECTOR
CABLE
2)Remove the nut and washer that secure the cable eyelet to the deflector.
3)Remove the nut, washer and bracket that secure cable to the chute.
DEFLECTOR
CONTROL
LEVER
SCREWS
DEFLECTOR
CABLE
ASSEMBLY
4)Remove both 5/16" screws that secure cable assembly to the handle assembly.
5)Cut the cable ties that secure the cable to the snowthrower, paying attention to the routing of the cable and the location of ties.
6)Reverse process to install the cable and new plastic ties.
31
www.mymowerparts.com
