For Husqvarna Parts Call 606-678-9623 or 606-561-4983

6.31Adjustment for Power Steering Slips * Operate to determine which side is slipping.

* Reinstall Thrust Washer (p 37 key 27), Axle Lobe (26), Wheel Lobe (23), and Retaining Ring (key 33). * Pull axle shaft outward to maximize tolerances.

FEELER GAUGE

RETAINER RING

* Place Snowthrower with Auger end down.

*Remove wheel and power steering parts on side with slipping power steering, Section 7.22.

*Measure the gap between the Wheel Lobe (part 179136) and the Retaining Ring (key 33).

*If the gap is .030" or more, install an additional 174697 Hardened Thrust Washer next to the Axle Bearing to eliminate slip.

*Reinstall all parts with needed thrust washers.

*Use antiseize compound on splined parts during reassembly. Refer to page 33 for exploded parts view.

26

www.mymowerparts.com

Page 26
Image 26
Electrolux OHV service manual Feeler Gauge Retainer Ring