For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Section 7.18: Replace Speed Control Linkage or Speed Control Assembly
1)Check for proper linkage adjustment in Section 6.24 before replacing part.
2)Remove control panel (see section 7.11 )
RETAINER
SPRINGS
3)Remove retainer spring from both ends of linkage.
SCREWS
SPEED CONTROL
ASSEMBLY
4)Remove the two 5/16" hex head screws holding control to handle assembly.
5)Reverse process to install a new linkage and perform adjustment in Section 6.24.
Section 7.19: Remove and Replace Power Steering Control Cable
1)Remove fuel from fuel tank
2)Position blower auger end down.
3)Remove klik pin that secures wheel,
4)Remove wheel POWER STEERING COVER
5/16" SCREWS
NUT &
WASHER
5)Remove hardware that secures the power steering cover.
6)Cut wire ties that secure power steering cable to handle, noting location of ties.
BELLCRANK
PIN
7)Remove spring and pin holding bellcrank.
8)Unhook cable from bellcrank. Remove 5/16" screw that secures trigger to handle. Remove cable.
5/6" HEX HEAD SCREW
TURN TRIGGER
CABLE
9)Remove 5/16" screw that secures trigger to handle.
10)Reverse process to install cable.
32
www.mymowerparts.com
