For Husqvarna Parts Call
CONSUMER ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your new snow thrower.Your new snow thrower has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your snow thrower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
REMOVE SNOW THROWER FROM CARTON
1.Remove all accessible loose parts and parts boxes from carton.
2.Cut down all four corners of carton and lay panels flat.
3.Remove all packing materials except plastic tie holding speed control rod to lower handle.
4.Remove snow thrower from carton and check carton thoroughly for additional loose parts.
HOW TO SET UP YOUR SNOW THROWER
TOOL BOX (See Fig. 12)
A toolbox is provided on your snow thrower. The toolbox is located on top of the belt cover. Store the extra shear bolts, nuts and
NOTE: The
UNFOLD UPPER HANDLE
1.Raise upper handle to the operating position and tighten handle knobs securely.
INSTALL SPEED CONTROL ROD (See Figs. 1 and 2)
1.Remove plastic tie securing rod to lower handle.
2.Remove retainer spring from top end of rod.
3.Insert rod into speed control bracket and secure with retainer spring.
SPEED CON- |
|
TROL ROD |
|
PLASTIC TIE |
|
UPPER |
|
HANDLE |
|
HANDLE |
|
KNOB |
|
LOWER |
|
HANDLE |
|
FIG. 1 | 8 |
SPEED CONTROL ROD
RETAINER
SPRING
SPEED CONTROL | SPEED CONTROL | |
BRACKET | ||
LEVER | ||
|
FIG. 2
INSTALL TRACTION DRIVE CONTROL ROD (See Figs. 3 and 4)
The traction drive control rod has the long loop on the end of the spring as shown.
1.Slide rubber sleeve up rod and hook end of spring into pivot bracket with loop opening down as shown.
2.Remove retainer spring from top end of rod.
3.With top end of rod positioned under left side of control panel, push rod down and insert top end of rod into hole in drive control bracket. Secure with retainer spring.
TRACTION DRIVE |
CONTROL ROD |
RUBBER |
SLEEVE |
LOOP |
OPENING |
DOWN |
PIVOT |
BRACKET |
FIG. 3 |
www.mymowerparts.com
