Electrolux OHV For Husqvarna Parts Call 606-678-9623 or, Adjustment for Auger Control Rod

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

6.23 Adjustment for Auger Control Rod

*The Auger Control Rod is on the handle at the right side of the operator. Adjustment is required if engagement is sluggish or if the auger does not stop within 5 seconds of the release of the auger engagement lever.

PROTECTIVE

SLEEVE

CONTROL ROD

JAM NUT

*Raise protective Spring Sleve to expose jam nut.

*Loosen the jam nut.

*Remove hairpin and disconnect control rod from control lever.

*Turn the rod counter-clockwise to lengthen, clockwise to shorten.

*Reconnect the control rod to the control lever. The linkage should be slightly loose. If not readjust, then tighten jam nut.

*Test auger disengagement. Stopping time must be 5 seconds or less.

*If stopping is more than 5 seconds, readjust rod for more slack. Remove belt cover and check to see if idler arm will move freely by engaging auger control lever. Retest stopping time.

6.24 Adjustment for Speed Control Rod

*The Speed Control Rod is attached to the speed selector at the right side of the operator console. Adjustment is required when there are less than two speed positions for reverse.

*Speed Control in last notch ( 2nd reverse position)

2nd Reverse Position

SPEED CONTROL

ASSEMBLY

ADJUSTMENT

NUT and BOLT

BELLCRANK SHIFTER

RETAINER

SPRING

CONTROL ROD

LEVER

*Loosen the nut and bolt at the middle of the rod.

*Hold Bellcrank Shifter (p 35 key 33) in maximum counterclockwise position with one hand, and

tighten the nut and bolt with other hand.

25

www.mymowerparts.com