Electrolux OHV service manual For Husqvarna Parts Call 606-678-9623 or, Remove Frame Bottom Pan

For Husqvarna Parts Call 606-678-9623 or 606-561-4983

7.42 Remove Frame Bottom Pan

1)Remove fuel from fuel tank.

2)If repair involves removal of Drive Plate Assembly. See section 7.45.

3)Remove Belt cover. Use tape to hold end of Drive Belt Idler Spring in place, see page 37.

4)If the Drive Plate Assembly is to be removed, use a 3/8" drive ratchet with a 6" extension to remove tension from the traction drive belt by pulling up. Remove belt from engine pulley, see Section 7.34.

HEX HEAD

SCREWS

HEX HEAD

SCREWS

7.43Replace Rubber Wheel Ring or Hex Shaft

1)Remove wheels

2)Remove bottom pan (Section 7.42)

NUT

3/4" HEX SHAFT

3)Using a 3⁄4” wrench to hold the shaft , remove nut on right side

SCREWS

FLANGE

BEARING

4)Remove both screws that secure flange bearing on left side.

5)Position snowthrower so auger is down and handles are up.

6)Remove both wheels

7)Remove the four Hex Head Screws that hold the bottom pan to the frame.

8)Reverse to reassemble.

180017 FLANGE BEARING

180065 PINION GEAR

180066 LONG HEX SHAFT

5)Pull bearing/hex shaft assembly out from left side.

6)Remove Assembly with Rubber Wheel Ring from shifter fork and support Plates.

7)Replace Rubber Wheel Ring and torque bolts to 14-18 Ft.Lbs.

8)Reverse process to install. Lubricate hex shaft with metallic anti-seize before re- installing. Check to see that trunion bearing

round tabs are positioned in slots of shifter

40fork.

www.mymowerparts.com