Chicago Electric 45252 Workpiece and Work Area Set Up, General Operating Instructions, Safety

Page 9

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Workpiece and Work Area Set Up

Safety

1.Designate a work area that is clean and well- lit. The work area must not allow access by children or pets to prevent distraction and injury.

2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.

3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.

4.There must not be objects, such as utility lines, nearby that will present a hazard while working.

General Operating Instructions

The Impact Wrench is equipped with a rocker-type Trigger that can switch between clockwise (forward) rotation to counterclockwise (reverse) rotation.

1.Press the desired Socket (sold separately) onto the Anvil.

2.Plug the Power Cord into a 120V~ / 60Hz grounded outlet.

3.Press the LOWER part of the Trigger for clockwise (FORWARD) rotation or the UPPER part of the Trigger for counterclockwise (REVERSE) rotation.

Note: The Trigger will not activate if both settings are pressed down at the same time.

CAUTION! To prevent injury: Use both hands to operate the Impact Wrench, keeping one hand on the Handle and the other hand on the Housing. Do not hold or touch impact sockets during use.

4. When finished, release the Trigger.

Note: The amount of actual torque may vary depending on the condition of the threads and other factors. If tightening critical components, check the actual torque applied to the fastener with a mechanical torque wrench (not supplied).

5.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.

Setup

Operation

Maintenance

Item 45252

For technical questions, please call 1-800-444-3353.

Page 9

Image 9
Contents Page Table of Contents General Power Tool Safety WarningsWork area safety Electrical safety Personal safetySafety Setup Operation Maintenance Service Power tool use and careImpact Wrench Safety Warnings Fet SaVibration Safety Grounded Tools Tools with Three Prong Plugs Setup No rati OpeDouble Insulated Tools Tools with Two Prong Plugs GroundingSafety Setup SymbologyOperation Maintenance Extension CordsSpecifications Setup No rati Ope MaintenanSetup Before Use FunctionsSafety Workpiece and Work Area Set UpSetup Operation Maintenance General Operating InstructionsMaintenance and Servicing Cleaning, Maintenance, and LubricationProblem Possible Causes Likely Solutions TroubleshootingParts List and Diagram Parts ListAssembly Diagram Fet Sa Setup No rati Ope Maintenan Limited 90 Day Warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800