5.Verify that the RED Charging Indicator Light comes on. If it does not illuminate, check the power connection or try a different electrical outlet. Charge the Battery
(37)for 1 hour. NOTE: When the Battery is fully charged the RED Charging Indicator Light will turn off, and the GREEN Charged Light will illuminate. Subse- quent charging can also be done in 1 hour. (See Figure D.)
6.While charging, the Battery (37) and Charger (39) may become warm to the touch. This is normal, and does not indicate a problem. (See Figure D.)
7.Once the Battery (37) is fully charged, disconnect the Charger (39) from the electrical outlet. Remove the Battery from the Charger, and insert the Battery into the handle of the Impact Wrench. (See Figure D.)
8.NOTE: If charging more than one Battery (37), allow the Charger (39) to cool down before reusing. (See Figure D.)
OPERATING INSTRUCTIONS
1.Before installing a socket, make sure the Battery (37) is removed from the Impact Wrench to avoid accidental starting. Then, firmly insert the Socket onto the 1/2” Impact Head (7) of the tool. (See Figure D.)
2.Whenever possible, secure the workpiece in place, using a vise or clamps (not included).
3.Insert the fully charged Battery (37) into the handle of the Impact Wrench.
(See Figure D.)
4.Use the Forward/Reverse Switch (32) to select the turning rotation of the Impact Wrench. (See Figure D.)
5.Insert the socket onto the nut that is to be loosened/tightened.
6.Make sure to hold the Impact Wrench firmly with both hands, as torque from the Motor will cause the tool to twist. Then, squeeze the Trigger (36) to turn on the Impact Wrench. (See Figure D.)
7.When finished, release the Trigger (36) to stop the Impact Wrench. Then, re- move the Battery (37) and socket from the tool. (See Figure D.)
8.Make sure to store the Impact Wrench in a dry, clean location out of reach of children and other unauthorized people.
REV 03/05
SKU 92798 | For technical questions, please call | Page 11 |