Maintenance (Cont’d)
4.Weekly, or more often if used on a daily basis, use a grease gun (not included), to inject grease into the Grease Fitting. Put in only a drop or two. See FIGURE 3.
5.If you do not use an inline oiler/filter system, lubricate the tool daily by holding it so that the Air Inlet (10) is facing up. Squeeze the Trigger (4), and place one or two drops of oil into the Air Inlet (10). Squeezing the Trigger (4) allows the oil to circulate in the motor.
Figure 1
Air Inlet (10)
Trigger (4)
Air Regulator (12)
Figure 2
| 2 |
3 | 1 |
| 4 |
The Air Regulator (12) has an index from 1 to 4. Push and turn the Air Regulator (12) to a higher number, 3 or 4, for more air flow and more power. Push and turn it to a lower number, 2 or 1, for less power.
Anvil (18)
Figure 3
| F | R |
|
| |
Forward |
| Reverse |
Grease Fitting
SKU 93566 | For technical questions please call | Page 6 |