Tightening
Step 1: Verify that the power level is correct for your needs and that the REVERSE VALVE (#48) has been shifted (pressed) completely to the left. If not, refer to Steps 5 through 9 under Use before proceeding.
Step 2: Place your work in as clear a location as possible. Make sure the air hose will reach as far as needed without stressing any connections.
Step 3: Thread the nut or bolt on as far as possible by hand. This is to prevent
Step 4: If you have torque specs for the nut or bolt you are working on, refer to them. If a low torque setting is given, it is recommended that you use a socket wrench or a manual torque wrench to tighten as the Impact Wrench may provide too much torque, even in the lowest power setting.
Step 5: Place the socket onto the nut or bolt.
Step 6: Grip the Impact Wrench with both hands, especially with higher power settings. Make sure you are in a stable position and spread your feet
Step 7: Press the TRIGGER to tighten the bolt.
Step 8: When the bolt is tight, release the TRIGGER. DO NOT OVER TIGHTEN!
MAINTENANCE
There are no
Refer to OPERATIONS Setup for information on maintaining your tool.
Wipe down your tool after every use and store it in a drawer or other safe place
SKU 32871 For technical questions, please call | Page 9 |