Harbor Freight Tools operating instructions SKU 94903 For technical questions please call

Page 3

9.Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running machines.

10.Maintain tools with care. Keep tools maintained and clean for better and safer performance. The handles must be kept clean, dry, and free from oil and grease at all times.

11.Avoid unintentional starting. Be sure the switch is in the Off position when not in use. Do not carry any tool with your finger on the start switch.

12.Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.

13.Take caution as some woods contain preservatives such as copper chromium arsenate (CCA) which can be toxic. Some metals and other materials can be toxic when burned. When cutting or burning these materials extra care should be taken to avoid inhalation and minimize skin contact.

14.Check for damaged parts. Before using any tool, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn On and Off properly.

15.Guard against burns. This tool and your work materials will become very hot when in use. Prevent body contact with hot surfaces by using safety equipment such as gloves. Provide for cooling trays for tools and work materials.

16.Replacement parts and accessories. When servicing, use only accessories intended for this tool.

17.Do not operate tool if under the influence of alcohol or drugs. Read warning labels on prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any doubt, do not operate the tool.

18.Maintenance. For your safety, service and maintenance should be performed regu- larly by a qualified technician.

19.The brass components of this product contain lead, a chemical known to the State of California to cause birth defects (or other reproductive harm). (Cali- fornia Health & Safety code 25249.5, et seq.)

20.WARNING: The warnings, cautions, and instructions discussed in this instruc- tion manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

SKU 94903 For technical questions please call 1-800-444-3353

Page

Image 3
Contents Distributed exclusively by Harbor Freight Tools For technical questions or replacement parts, please callSKU 94903 For technical questions please call SpecificationsSafety Warnings and Precautions Save This ManualSKU 94903 For technical questions please call Unpacking Igniting and Extinguishing The Torch Soldering Iron Stand Gas on Lock Switch Gas on Lock ButtonSetting up the Soldering Iron OperationContinuous Flame Flame AdjustmentUsing The Torch as a Hot Blower Using The Pencil Torch FeatureSoldering Iron Stand MaintenanceCleaning and Storing Using The Soldering Iron StandSoldering Hints