Operation
Igniting and Extinguishing The Torch:
1.To ignite the torch push the Gas “On/Off” Switch forward towards the tip until the Gas “On” Lock button pops out. This will lock the Gas “On/Off” switch in the “On” position.
2.Next push the “Piezo Igniter” button forward repeatedly until the torch is lit.
3.To turn off the torch, push the Gas “On” Lock button. By doing this the Gas “On/Off “ switch will slide to the off position and extinguish the flame. If the flame continues to burn, press the “Flame Off Button”.
4.Allow the tool to cool down before setting it down. Only set the tool down after the stand has been opened. See page 7 for instructions regarding this.
WARNING: Never leave the tool unattended while in operation or while hot. Serious personal injury and risk of fire may result.
Soldering Iron Adapter | Piezo Igniter |
|
Adapter Lock Nut |
|
Soldering Iron Stand | Gas “ON” Lock Switch |
Gas “ON” Lock Button
Setting up the Soldering Iron:
1.The Torch comes with the “Soldering Iron Adapter” already installed. It is the longer of the two adapters and has a threaded end that receives the soldering tips.
2.If you do need to install “Soldering Iron Adapter”, first remove the “Adapter Lock
Nut” then slide the “Soldering Iron Adapter” over the ceramic insulator, then thread on the “Adapter Lock Nut”.
3.Pick the desired tip from the kit and screw it onto the end of the “Soldering Iron Adapter”.
REV 07j
SKU 94903 For technical questions please call | Page |