Flame Adjustment:
To adjust the flame, move the “Flame Adjustment Lever”, located under the torch, toward the “+” to increase the flame or toward the
Continuous Flame:
1.To keep the flame locked on, push in the Gas “ON” Lock Button during ignition to activate the Continuous Flame Mechanism.
2.To turn OFF the flame, push the Continuous Flame Switch forward. The Lock Button will pop out. Press the Flame OFF button.
Using The Torch as A Hot Blower:
1.To use the tool as a Hot Blower first remove the soldering tip and sleeve assembly by rotating them counterclockwise. With no soldering tip attached, the tool can be used as a Hot Blower.
2.Operate the tool as discussed on page 5, “Igniting and extinguishing the Torch”. Hot air, but no flame will be blown from the tip of the tool. The picture below shows what the tool should look like when you use it as a Hot Blower.
Flame Adjustment Lever
WARNING: The hot air blowing from the tip of the tool will not be visible as flame, but can cause severe burns. Be extremely cautious; do not cause injury to yourself or others and do not point the blower at any person, animal or flam- mable object.
Using The Pencil Torch Feature:
1.To use the pencil torch feature first remove the “ Adapter Lock Nut” and the “Solder- ing Iron Adapter”. See page 5.
2. | Next install the “Torch Adapter” by sliding it over the ceramic insulator. Then rein- |
| stall the “Adapter nut”. |
SKU 94903 For technical questions please call | Page |