Parkside PLBS 30 A1 manual Personal safety

Page 10

Safety advice

c)Use a residual current device (RCD) for protection if operating the electrical power tool in a moist envi- ronment is unavoidable. The use of an RCD reduces the risk of electric shock.

d)Do not use the mains lead for any purpose for

which it was not intended, e.g. to carry the device, to hang up the device or to pull the mains plug out of the mains socket. Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. Damaged or tangled mains leads increase the risk of electric shock.

e)Do not operate the device if the mains lead or mains plug is damaged.

A damaged mains lead presents a serious danger to life from electric shock.

f)Always keep the mains lead out of the operating area and run it away from the rear of the device.

g)Always pull out the mains plug if you are about to leave the device unattended or wish to carry out any tasks on the device.

3.Personal safety

a)Children or persons who lack the knowledge or ex- perience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or in- struction by a person responsible for their safety. Children must never be allowed to play with the device.

b)Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of

10 GB/IE

Image 10
Contents Fine Soldering Iron SET Plbs 30 A1 GB / IE Page Page Table of contents Introduction Fine soldering iron set Plbs 30 A1 Introduction Proper useIncluded items Features and equipmentTechnical information Workplace safety Safety adviceElectrical safety Personal safety Safety advice Careful handling and use of electrical power tools Always wash your hands immediately after solderingBefore first use Safety advice / Before first useOriginal accessories / attachments Fitting the helical springThird hand Switching on and offOperation Solder spongeClean the soldering tip 2 on the moist solder sponge SolderingOperation / Maintenance and cleaning Maintenance and cleaningService centre Service centre / WarrantyWarranty Warranty / Disposal DisposalDisposal / Declaration of Conformity / Manufacturer Declaration of Conformity / ManufacturerDeclaration of Conformity / Manufacturer 20 GB/IEKompernass Gmbh