Parkside PLBS 30 A1 manual Operation, Switching on and oﬀ, Third hand, Solder sponge

Page 14

Operation

Operation

Switching on and oﬀ

Switching on:

Insert the mains plug into a suitable mains socket.

Switching off:

Pull the plug out of the mains socket to switch oﬀ the device.

Third hand

CAUTION! DANGER OF BURNS! The clips on the third hand 5 can become hot while you are soldering the workpiece.

1.Fold out the third hand 5 upwards.

2.Rotate the clips 4 until they are oriented in the required direction.

3.Clamp the workpiece between the two clips 4 .

Solder sponge

CAUTION! The hot soldering tip 2 must never be placed in contact with a dry solder sponge 8 , otherwise the solder sponge may be damaged.

The solder sponge 8 is used to clean soldering tips.

Moisten the solder sponge 8 before you use it.

14 GB/IE

Image 14

Contents Fine Soldering Iron SET Plbs 30 A1 GB / IE Page Page Table of contents Introduction Fine soldering iron set Plbs 30 A1 Introduction Proper useTechnical information Features and equipmentIncluded items Electrical safety Safety adviceWorkplace safety Personal safety Safety advice Careful handling and use of electrical power tools Always wash your hands immediately after solderingBefore ﬁrst use Safety advice / Before first useOriginal accessories / attachments Fitting the helical springThird hand Switching on and oﬀOperation Solder spongeClean the soldering tip 2 on the moist solder sponge SolderingOperation / Maintenance and cleaning Maintenance and cleaningWarranty Service centre / WarrantyService centre Warranty / Disposal DisposalDisposal / Declaration of Conformity / Manufacturer Declaration of Conformity / ManufacturerDeclaration of Conformity / Manufacturer 20 GB/IEKompernass Gmbh