Grizzly Model G1033Z manual Dust Hood Switch, Attaching switch

The G1033 features a dust hood with a 5'' dust port. It is only to be used in conjunction with a dust collection system. Install the dust hood as follows:

1.Match the mounting holes on the dust hood with the tapped holes on the outfeed end of the cutterhead casting.

2.Using the six M6-1.0 Hex bolts provided, secure the dust hood to the cutterhead casting. See Figure 4.

See note regarding the use of a dust collector and chip deflector adjustment in the adjustment section of this manual.

DO NOT attach the dust hood if you do not intend to connect the Model G1033 to a dust collection system. Accumulated wood chips could cause a malfunction, resulting in per- sonal injury or damage to the planer.

The magnetic ON/OFF switch supplied with the Planer is pre-wired to the motor. The remaining step requires connecting the switch to the plan- er's head casting. To attach the switch:

1.Align the holes on the flanges at the back of the switch box with the tapped holes on the front left corner of the head casting.

2.Using the socket head cap screws provid- ed, attach the switch box assembly to the head casting. See Figure 5.

The G1033 is shipped without a plug. Now would be a good time to attach the appropriate plug specified in Section 2: Circuit Requirements.

Do not attempt to make any adjustments to this machine or perform routine mainte- nance without unplugging it from its power source. Serious injury could result.