Grizzly Model G1033Z manual Clean Up, Site Considerations

Clean Up

The unpainted surfaces are coated with a waxy oil to protect it from corrosion during shipment. Remove this protective coating with with a sol- vent cleaner or citrus-based degreaser. Avoid chlorine-based solvents as they may damage painted surfaces should they come in contact. Always follow the usage instructions on the prod- uct you choose for clean up.

Many of the solvents commonly used to clean machinery can be highly flammable, and toxic when inhaled or ingested. Always work in well-ventilated areas far from poten- tial ignition sources when dealing with sol- vents. Use care when disposing of waste rags and towels to be sure they do not cre- ate fire or environmental hazards. Keep chil- dren and animals safely away when clean- ing and assembling this machine.

Do not use gasoline or other petroleum- based solvents to remove this protective coating. These products generally have low flash points which makes them extremely flammable. A risk of explosion and burning exists if these products are used. Serious personal injury may occur.

Some die-cut metal parts may have sharp edges (called “flashing”) on them after they are formed. Please examine the edges of all die-cut metal parts before handling them. Failure to do so could result in injury.

Site Considerations

FLOOR LOAD

Your G1033 Planer represents a large weight load in a small footprint. Most commercial floors are suitable for the Model G1033. Some residen- tial floors may require additional build up to sup- port both machine and operator.

WORKING CLEARANCES

Working clearances can be thought of as the dis- tances between machines and obstacles that allow safe operation of every machine without limitation. Consider existing and anticipated machine needs, size of material to be processed through each machine, and space for auxiliary stands and/or work tables. Also consider the rel- ative position of each machine to one another for efficient material handling. Be sure to allow your- self sufficient room to safely run your machines in any foreseeable operation.

LIGHTING AND OUTLETS

Lighting should be bright enough to eliminate shadow and prevent eye strain. Electrical circuits should be dedicated or large enough to handle combined motor amp loads. Outlets should be located near each machine so power or exten- sion cords are not obstructing high-traffic areas. Be sure to observe local electrical codes for prop- er installation of new lighting, outlets, or circuits.

Make your shop “child safe”. Ensure that your workplace is inaccessible to young- sters by closing and locking all entrances when you are away. Never allow visitors in your shop when assembling, adjusting or operating equipment.