Sanyo SAP-KRV94EHDX Care and Cleaning continued, Remounting the front panel, Anti-MoldFilter

Care and Cleaning (continued)

Remounting the front panel	• Reattach the subgrille onto the front
	panel then tighten the five levers.
	• Support the nearest point of the front
	panel keeping it horizontal then push
	arm axis to the grooves at the top of
	the indoor unit.
	• Press the locations marked by the
	arrows and close the front panel.

Front panel Groove

Front panel

CAUTION

Anti-Mold Filter

When using a footstool or the like, be careful not to let it tip over.

The anti-mold filter behind the front panel should be checked and cleaned when the red FILTER (ION) lamp lights as follows;

The FILTER (ION) indicator lamp lights after 250 operation hours.

The indication will beep 4 times before the FILTER (ION) lamp flashes for 6 seconds after another 125 (375 total operation) hours, indicating the anti- mold filter should again be checked and cleaned.

If you want to turn the FILTER (ION) lamp off or on after cleaning the anti- mold filter, press the FILTER RESET button in the indoor unit with a small pointed tool.

How to remove the anti-mold	1. Open the front panel	Air clean filter
filter	until it is nearly
		Front panel
	horizontal, grasp the
	sections near the
	front panel arms on
	both sides, and then
	pull forward to remove
	the front panel.

2. Remove the anti-mold filter, attached to the rear of the front panel.

Anti-mold filter

Cleaning Use a vacuum cleaner to remove light dust. If there is sticky dust on the filter, wash the filter in lukewarm, soapy water, rinse it in clean water, and dry it.

How to replace the anti-mold 1.	Insert the top of the anti-
filter	mold filter, align the two
	indentions with the center
	hook at bottom, then mount
	the filter into place.
2.	Press the locations marked
	by the arrows and close the
	front panel.

Anti-mold filter

indention center hook

Front panel

OI-791-23-EG 23