Adjusting the Airflow Direction
The horizontal and vertical airflow can be adjusted by moving the vertical vanes and the flap with the remote control unit. Confirm that the remote control unit has been turned on. Use the FLAP button to set either the sweep function or one of the six airflow direction settings.
CAUTION
1.Horizontal
When the humidity is high, the vertical vanes should be in the front position during the cooling or dehumidifying operation. If the vertical vanes are positioned all of the way to the right or left, condensation may begin to form around the air vent and drip down.
Auto | Wide Sweep |
A. Sweep function
The vertical vanes move left and right to deliver air over the sweep range.
B. Setting the airflow manually
Referring to above illustration, use the FLAP button to set the airflow direction within the range used during the heating, cooling or dehumidifying operation.
C. Auto flap function
The flap is set to the recommended position. |
| ||
2.Vertical A. Sweep function |
|
|
|
The flap starts moving up and down |
|
|
|
|
|
| |
to deliver air over the sweep range. |
|
|
|
B. Setting the airflow manually |
| SWEEP |
|
Referring to the above illustration, |
|
|
|
use the FLAP button to set the airflow |
|
| SWEEP |
direction within the range used during | COOL |
| |
the heating, cooling, or dehumidifying |
| ||
| DRY |
| |
operation. |
|
| |
| FAN | HEAT | |
|
| ||
C. Auto flap function
The flap is set to the recommended position.
NOTE
CAUTION
•The flap automatically closes when the unit is off.
•During the heating operation, the fan speed will be very low and the flap will be in the horizontal position (position 
) until the air being blown out of the unit begins to warm. Once the air warms up, the flap position and fan speed change to the settings specified with the remote control.
•Use the FLAP button on the remote control to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote control and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
•Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
21 | |
|
