Remote Control Unit (continued)
SENSOR button | When you press this button (use a | |||
|
|
| pen), the | mark will appear at the display. And the room temperature is |
|
|
| detected by the sensor which is built into the indoor unit and the air | |
|
|
| conditioner is controlled accordingly. | |
|
|
| If the remote control is located near a heat source, such as a space heater or | |
| NOTE |
| ||
|
|
| in direct sunlight, press the SENSOR button to switch to the sensor on the | |
|
|
| ||
|
|
| indoor unit. |
|
|
|
|
| |
Temperature Display Selector | This switches the temperature display between °C and °F. | |||
| button |
|
| |
|
|
|
| |
Time Display Selector button | This switches the time display between | |||
|
|
|
| |
TIMER Selector button | This button switches ONE TIME or EVERYDAY. When you select | |||
(ONE TIME/EVERYDAY) | EVERYDAY, | is displayed and continuously operates this function | ||
|
|
| everyday. The initial setting is EVERYDAY. If you select ONE TIME, it | |
|
|
| operates until setting time of timer. | |
|
|
|
| |
CANCEL button | If you want to cancel the setting time of ON or OFF, press the ON or OFF button | |||
|
|
| first, then press the CANCEL button. The CANCEL function is invalid for the | |
|
|
| 1.2.3.5HR. TIMER. | |
|
|
|
| |
CLOCK button | The CLOCK button is used to set the present time. Press the CLOCK button | |||
|
|
| first, then select the advance or return keys on the ON or OFF TIME setting | |
|
|
| button. Press the CLOCK button again to set adjusted present time. | |
|
|
|
| |
CHILD LOCK button | The CHILD LOCK button is used to tamperproof and protect the unit from | |||
|
|
| being incorrectly operated. The setting or canceling this function is effected | |
|
|
| by pressing the button for at least two seconds.The initial setting is set to | |
|
|
| CHILD LOCK off. | |
|
|
| : CHILD LOCK on. | |
|
| All key access functions are invalid while the CHILD LOCK function is on. | ||
| NOTE |
| ||
|
|
|
| |
|
|
|
|
|
ADDRESS switch | • The ADDRESS switch changes to prevent mixing of signals from remote | |||
|
|
| control units when two air conditioners are installed next to each other. | |
|
|
| The ADDRESS switch is located inside of rear cover on the remote | |
|
|
| control unit, and is set to A. For more information, please contact the | |
|
|
| dealer where you made the purchase. | |
|
|
| • Normally, tab on the remote control unit should not be bent. | |
|
|
|
|
|
NOTE
The remote control unit sends the temperature signal to the air conditioner regularly at five minute intervals. If the signal from the remote control unit stops for more than 15 minutes due to the loss of the remote control unit or other trouble, the air conditioner will switch to the temperature sensor which is built into the indoor unit and control the room temperature. In these cases, the temperature around the remote control unit may differ from the temperature detected at the air conditioner’s position.
Using the Remote Control Unit
How to Install Batteries
1. Slide the cover in the direction indicated by the arrow and remove it.
2. Install two AAA alkaline batteries. Make sure the batteries point in the direction marked in the battery compartment.
10 | |
|