Sanyo SAP-KRV94EHDX service manual Removing the Panel Motor

(4-3) Disconnect all the connectors on the P.C.Board.

(4-4) Replace the P.C.Board.

Remove this tab first, and then

Tab remove other tabs while slightly raising the P.C.Board.

P.C.Board

Electrical component box cover

(4-5) Pulling out the lead wire after replacing the P.C.Board.

8-4. Removing the Panel Motor

Remove the electrical component box cover according to the previous section.

And carry out the procedure up to the "stepPanel motor (4-2) in 8-3. Removing the electrical

component box."

P.C.Board

(1)Disconnect and remove the connector for the lead wire of the panel motor at the P.C.Board

side.

(2) Remove the screw on the panel motor and cap (resin).

Electrical component box cover

Screw

Cap (resin)

Panel motor

Electrical component box cover

To the

P.C.Board

NOTE When mounting a new panel motor, make sure that the gear of the panel motor and that of the electrical component box cover firmly engage with each other.

32