Sanyo SAP-KRV94EHDX Remove the Grille to Install the Indoor Unit, How to remove the grille

7-5. Remove the Grille to Install the Indoor Unit

Basically, these models can be installed and wired without removing the grille. If access to any internal part is needed, follow the steps as given below.

How to remove the grille

(1)Open the front panel until it is nearly horizontal, grasp the sections near the front panel arms on both sides, and then pull forward to remove the front panel. (Fig. 9)

(2)Remove the screw from the top right of the main unit. Also remove the screws where the screw covers are open. (Fig. 10)

(3)Press the 3 tabs on the top of the grille to disengage them. (Fig. 10)

(4)Pull the grille toward you to remove it. (Fig. 10)

How to replace the grille

(1)Insert the bottom of the grille into the flap, with the flap at a more-or-less horizontal position.

(2)While aligning both edges of the grille with the frame, move the panel horizontally and insert the top and bottom into the frame.

(3)Press the air outlet firmly with your hand to ensure no gap exists between the main unit and grille.

(4)Tighten the screws and close the screw covers.

(5)Grasp the sections near the front panel arms on both sides, hold the front panel so that it is nearly horizontal, bring the arm shafts into contact with the top of the grooves on the right and left sides of the air conditioner, and then push firmly until the arm shafts click into place. (Fig. 11)

(6)After closing the front panel, press firmly on the parts indicated by the arrows to securely fasten the panel in place. (Fig. 12)

NOTE

Check that no gap exists between the main unit and grille.

Front panel

Arm

Fig. 9

Screw

Grille

Screw

Flap

Screw cover

Fig. 10

Front panel

Groove

Pin

Arm

Fig. 11

Fig. 12

27