Grizzly Model G1033Z manual Assembly, Overview, Extension Rollers, Hand Wheel

Page 13

SECTION 4: ASSEMBLY

Overview

Most of your G1033 Planer has been assembled at the factory, but some parts must be assembled or installed after delivery. We have organized the assembly process into steps. Please follow along in the order presented here.

TOOLS REQUIRED: Most of the tools required for assembly are included with the planer. However, you will also need a Phillips¨ and regu- lar screwdriver, metric wrenches, as well as a feeler gauge for adjustments.

Extension Rollers

The Model G1033 is supplied with extension rollers on both the infeed and outfeed ends of the table. The roller assemblies are identical for both infeed and outfeed. To attach the extension rollers:

1.Attach an extension bar to the end of each roller and secure with the 12mm snap rings provided.

2.The assembled extension rollers attach to the ends of the planerÕs table. Match the tapped holes on the side of the table to the extension bars and attach with the M10 x 1.5 Hex Bolts and washers provided. See

Figure 2.

3.Before final tightening, run a straight edge across the table and past each roller. Position the rollers flush with the table and tighten the Hex Bolts securely.

Extension

Mounting Bolts

Figure 2. Extension roller attachment.

Hand Wheel

The hand wheel operates the chain driven sys- tem which raises and lowers the table to control cutting depth. To attach the hand wheel:

1.Place the handwheel on the worm gear shaft and secure with hex nut and washer provided. See Figure 3.

2.Attach the handle to the handwheel and tighten hex nut.

Figure 3. Attaching handwheel.

 

 

 

 

 

 

 

 

G1033 20" Planer

 

-9-

 

Image 13
Contents 20 5 HP Planer Manual InsertG1033Z Replacement Parts Planer Page Table Of Contents Safety Instructions For Power Tools SafetyAMP Rating Additional Safety Instructions For Planers Circuit Requirements Fusing220V Operation Grounding Extension CordsCommentary IntroductionParts Inventory UnpackingSite Considerations Clean UpOverview AssemblyExtension Rollers Hand WheelAttaching switch Dust Hood SwitchKnife setting jig Knife Setting JigChain Adjustment Table Adjustment AdjustmentsChain Drive Micro-adjustment screws G1033 20 PlanerBed Rollers Knife Inspection Knife AdjustmentFeed Roller Speed Roller AdjustmentTension screw locations G1033 20 Planer Spring TensionChipbreaker Pressure Bar Chip Deflector Static Chain AdjusterAnti-Kickback Fingers Scale AdjustmentTest Run Operational Tips OperationsWood Characteristics General MaintenanceKnife Sharpening Feed roller lubrication points G1033 20 Planer LubricationBelt Tension Belt Alignment Closure Machine Data Sheet Symptom Possible Cause Corrective Action Troubleshooting107 108 8894 109 Headcasting Middle Table 297 2810 Stand Gear BOX PSB18M G1033 20 Planer G1033 Wiring Diagram -Taian Type Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC