Grizzly Model G0550 instruction manual Knife Setting Jig, To assemble the knife setting jig

Knife Setting Jig

Components and Hardware Needed: Qty
Knife Jig Shaft	1
Knife Jig Feet	2
E-Clips 9mm	4
To assemble the knife setting jig:

1.Snap one of the E-clips over the notch on one end of the knife setting shaft.

2.Slide the cast aluminum knife setting jig feet onto the rod.

3.Snap the other E-clip onto the notch at the other end of the knife setting jig shaft.

Jig Shaft

E-Clip

Jig Feet

Figure 14. Knife setting jig.

-18- G0550/G0551 15" Planer