Adjusting Pressure BAR

IMPORTANT: THE PRESSURE BAR IS SET AT THE FACTORY AND SHOULD NOT NEED ASJUSTMENT. BUT WHEN KNIVES ARE SHARPENED OR REPLACED THE PRESSURE BAR SETTING SHOULD BE CHECKED AND ADJUSTED IF NECESSARY.

The pressure bar is located directly behind the cutter- head and rides on the planed surface of the stock, pressing the stock down on the table. If the stock does not feed, the pressure bar is set too low. If the stock has chatter marks, the pressure bar is set too high. The pres- sure bar must be parallel to the knives and set .040" below the cutting circle.

To check and adjust the pressure bar, proceed as fol- lows:

1. DISCONNECT MACHINE FROM POWER SOURCE

2.Remove the four screws that attach the top cover (A) Fig. 24A to the planer and carefully remove the top cover.

3.Make certain the knives are adjusted properly as previously explained under CHECKING, ADJUSTING AND REPLACING KNIVES.

4.Place the guage block (A) Fig. 24B, on the table directly underneath the cutterhead as shown. Place a

.040" feeler guage (B) Fig. 24B, on top of the guage block and raise the table until the knife (C) just touches the feeler guage when the knife is at its lowest point.

5.Next, set the feeler guage aside and move the guage block (A) Fig. 25, directly underneath the pressure bar (B) on one end of the table. The pressure bar (B) should just touch the guage block (A). Check the pres- sure bar at the opposite end of the table in the same manner.

6.If the pressure bar must be adjusted, remove screw

(D) Fig. 26. Loosen screw (E) Fig. 26A, three or four turns. Turn screw (F) Fig. 26A clockwise to raise the bar or counter clockwise to lower the bar. The bottom of pressure bar should just touch the gauge block (A) Fig.

8.Then tighten screw (E) Fig. 26A until it bottoms and then loosen it two complete turns. Replace screw (D) Fig. 26A.

9.This adjustment to the pressure bar should be made on the opposite end of the planer In the same manner.

Fig. 24A

			C
	B		C
	B

Fig. 24B

Fig. 25

Fig. 26

Fig. 26A