TO MOUNT THE WOOD PIECE
1.Cut a standard 2 x 4 (H) to 35.75" (910 mm) long.
2.Align the 2 x 4 in the top channel of the beam (A).
3.Secure the 2 x 4 to the beam with 2" (50.8 mm) long wood screws inserted from below through the holes in the main beam.
NOTE: When the wood surface is attached, a miter saw mounting bracket can not be attached to the stand.
Working With Pipes (Fig. 5) | FIG. 5 |
If cutting or otherwise working with pipe, the |
|
stand has a V notch (I) on each side of the | I |
stand to help keep the pipe from rolling | |
when cutting. |
|
Carry Handle (Fig. 7)
A handle has been supplied to transport the work stand to and from the work site.
WARNING: To reduce the risk of personal injury, DO NOT attempt to store or carry the work stand with a tool attached. Loss of control may result.
Clamping Work Material (Fig. 8)
The work stand is compatible with the DWS5026 track saw clamp. Insert the clamp's base into the large rectangular hole (K) in the stand end bracket and clamp down on your work material.
FIG. 7
English
FIG. 8
K
Carry Strap |
If you purchase the carry strap accessory for |
DEWALT stands, use the small square hole |
in the metal end to mount the accessory. |
Wall Mount Storage
If you would like to store your stand out of the way you can mount your stand on the wall. Install a wood screw into a stud, leave a portion protruding from the wall. Use the V notch on the bottom of the metal end to hang the stand vertically on the screw.
Locking Locator Clip (Fig. 6) FIG. 6
The locking locator clip (J) keeps the optional DW7231 accessory from sliding left or right during cutting operations. It is fixed on the DWX725.
J
Accessories
WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, do not create unstable conditions and use only with DEWALT tools.
COMPATIBLE PRODUCTS
DW7231 – Miter saw mounting brackets DW7026 – Carry strap
DWS5026 – TrackSaw™ clamp
Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, call
3