1.Unscrew and remove the Bolts (16) on the Blade Guard (14), slide Blade Guard slightly to the right, and lift it. See Figure D.
Blade Guard (14)
Magnets (123)
Gib (56)
Figure D
2.Using gloves, rotate the Cutterhead
(53)so that the Screws (55) are accessible.
3.Using the Hex Wrench (122), unscrew and remove the six Screws
(55)securing the Gib (56). See Figure D. Place the Screws in a safe location.
4.Using the two tool Magnets (123), lift the Gib off and set aside.
5.Using the two Magnets (123), lift the Blade (57) off the Cutterhead (53). See Figure E.
Note: Leave Springs (58) in place.
Magnets (123)
Gib (56)
Blade (57)
Cutterhead (53)
Figure E
6.Since the Blade has a
(123).WARNING! Do not attempt to sharpen blades, only replace them.
Use the pins located on each side to position the Blade in place.
7.Replace the Gib over the Blade and secure with the six Screws.
Securely tighten Screws using the Hex Wrench (122).
Blades require no adjustment and automatically locks into place.
8.Using gloves, rotate the Cutterhead
(53)so that the second Blade is accessible.
9.Repeat steps 2 through 8 on the second Blade.
10.Replace the Blade Guard (14) and secure with Bolts (16). Securely tighten Bolts.
SKU 95082 | For technical questions, please call | Page 13 |