SpecificationsAssembly
Electrical Requirements | 120 V~ / 60 Hz / 11.8 A | |
|
| |
Motor (Cutter head) | ||
Speed | per minute | |
Maximum Cutting Depth | 3/32” | |
Stock Capacity | ||
Feed Speed | 20 Feet per Minute | |
Included | 1 | Hex Wrench (4mm) |
Accessories | 2 | Magnets, 1 Dust Bag, |
Unpacking
When unpacking, check to make sure item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation: Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Rev 10d
1.NOTE: This should always be mount- ed to a workbench before use.
1. Select an area with enough room to fit the chosen dust collection system. Select a workbench to mount the Planer. Place the Planer on a work- bench able to support the weight of the Planer and the wood stock being planed. The orientation of the Planer should enable the easy entry and exit of long pieces of wood stock.
2. Using a pencil, mark through the mounting holes of the Planer, onto the workbench. Slide the Planer aside and drill four 3/8 inch mounting holes into the workbench.
Before drill- ing, verify that there are no utility wires or other obstructions under the workbench.
3. Slide the Planer back over the mount- ing holes in the workbench, and se- cure the Planer to the workbench with bolts, washers, spring washers and nuts (not included). Securely tighten.
4. Mount the height (thickness) adjust- ment Handle (10) to the Right Cap (11). See Figure A.
Figure A
SKU 95082 | For technical questions, please call | Page 8 |