ADJUST ROLLER CASE LEVEL. If the Roller Case (47) is not parallel to the base (104), the planer will produce cuts of uneven depth.
1.Use a test piece to measure the height of the taper.
2.Turn the Planer off and disconnect it from the power supply.
3.Fold both Extension Tables up and lay the planer on its back.
4.Loosen the Head Screw (45) and Set Screw (44). Loosen the Chain (121) by sliding the Idler Bracket (114).
5.Rotate the Pan Head Screws (120) to correct the orientation of the Roller Case to Base. Each turn of the Screw will move the Roller Case by 1/16”.
REPLACING THE V-BELT.
1.Remove the Handle (10).
2.Remove the four Head Bolts (130A) and Head Washers (130B) from the Left Cap (1) and Right Cap (11).
Remove both Caps.
3.Remove the Pan Head Screws (68) from the Fan Housing (78). Slide off Fan Housing.
4.Remove the
26.Reassemble the Planer.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
SKU 95082 | For technical questions, please call | Page 14 |