SECTION 2: CIRCUIT REQUIREMENTS
110V Operation
Serious personal injury could occur if you connect the machine to the power source before you have completed the set up pro- cess. DO NOT connect the machine to the power source until instructed to do so.
Amperage Draw
The Model G0538 motor draws the following amps under maximum load:
Motor Draw | 2.4 Amps |
Power Supply Circuit Requirements
The power supply circuit for your machine MUST be grounded and rated for the amperage given below. Never replace a circuit breaker on an exist- ing circuit with one of higher amperage without consulting a qualified electrician to ensure compli- ance with wiring codes. If you are unsure about the wiring codes in your area or you plan to connect your machine to a shared circuit, con- sult a qualified electrician.
Circuit Breaker....................................... 10 Amps
Plug/Receptacle Type
Included Plug Type | NEMA |
Grounding Prong is |
|
Longest of the Three |
|
Prongs |
|
Current 
Carrying Prongs Grounded
Outlet
Figure 2. Typical type 5-15 plug and receptacle.
G0538 Oscillating Spindle Sander
Electrocution or fire could result if this machine is not grounded correctly or if your electrical configu- ration does not comply with local and state codes. Ensure compliance by checking with a qualified electrician!
This machine must have a ground prong in the plug to help ensure that it is grounded. DO NOT remove ground prong from plug to fit into a
Extension Cords
We do not recommend the use of extension cords, if you find it absolutely necessary:
•Use at least a 16 gauge cord that does not exceed 25 feet in length!
•The extension cord must also contain a ground wire and plug pin.
•A qualified electrician MUST size cords over 50 feet long to prevent motor damage.