Grizzly G0477 owner manual Roller Height Adjustment, To adjust the infeed/outfeed roller height

3.Place the workpiece below the depth-of-cut gauge, as shown in Figure 15.

Roller Height

Adjustment

The Model G0477 features three infeed/outfeed roller height settings. The provided special wrench is used to turn the roller height adjuster, as shown in Figure 16.

Figure 15. Depth-of-cut gauge.

4.Lower the headstock until it reaches the pre- set thickness. The headstock will not be able to move lower than the preset height.

5.If the depth-of-cut gauge reads greater than 3⁄32", repeat Steps 1–4with a larger thickness selected. We recommend making multiple, shallow passes for cuts deeper than 3⁄32" (1⁄16" for workpieces 8"–15" wide).

6.Remove the workpiece from the planer/ moulder.

7.Start the planer/moulder.

8.Place the flat side of the board down on the table, and feed the workpiece through the planer/moulder, making sure not to stand directly in front or behind the workpiece.

Roller Height

Adjuster

Figure 16. Roller height adjuster.

To adjust the infeed/outfeed roller height:

1.UNPLUG THE PLANER/MOULDER FROM THE POWER SOURCE!

2.Raise the headstock clear of the planer/ moulder table.

3.Use the special wrench provided to turn the roller height adjuster to one of the three pre- set settings shown in Figure 17.

���������������������������������������

������������������	���������
���������������	�����������������
Figure 17. Roller height adjuster settings.
Model G0477 15" Planer/Moulder	-19-