Grizzly G0477 Stand Assembly, Components and Hardware Needed Qty, To assemble the stand

Stand Assembly

The stand for the Model G0477 must be assem- bled before the planer/moulder can be mounted on it. It may be helpful to refer to the Stand Breakdown on Page 35 during this procedure.

Components and Hardware Needed:	Qty
Notched Legs*	2
Plain Legs	2
Long Frame Pieces	2
Short Frame Pieces	2
Long Braces	2
Short Braces	2
Carriage Bolts 5⁄16-18 x 3⁄4"	24
Flange Nuts 5⁄16-18	24

*These stand legs each have a small, semicircu- lar notch towards to top of the leg, as shown in Figure 5.

Leg Notch

Figure 5. Leg notches.

To assemble the stand:

1.Place a plain leg and a notched leg side-by- side on the ground, with the double bolt holes of the legs towards the top. The notched leg should be on the right of the unmarked leg.

2.Fasten a short frame piece to the legs using 5⁄16-18 x 3⁄4" carriage bolts and flange nuts.

3.Fasten a short brace piece to the legs, using carriage bolts and flange nuts.

4.Repeat Steps 1–3for the other side of the stand. The finished halves of the stand should look like those shown in Figure 6.

Plain Legs	Short Frame Piece
Short Brace Piece	Notched Legs

Figure 6. Stand halves.

5.Fasten the stand halves together using a long frame piece, a long brace piece, carriage bolts and flange nuts as shown in Figure 7.

Long Frame Piece

Long Brace Piece

Figure 7. Joining stand halves.

6.Fasten the remaining long frame piece and long brace piece to the stand using carriage bolts and hex nuts.

Model G0477 15" Planer/Moulder -13-