Black & Decker FHV1080 WARNING Injury to, Assembly, Mounting accessories figures A & B, hose

This product can accept any of the following chargers listed below. Model UA180020B or Model UA160015a

Assembly	A
Mounting accessories (figures A & B)			2
The 2-in-1 nozzle / brush tool (14) has a		10
brush that can be folded forward for dusting
and upholstery cleaning.
The pet hair cleaning tool (13) is for use
when vacuuming pet hair and/or ground-in
debris from carpeted or upholstery surfaces.
WARNING: Injury to	11
pets. Do not use pet hair cleaning tool
directly on animals.
The crevice tool (11) allows for vacuuming in
narrow and hard to-reach places.
• To attach an accessory (11), press the
accessory clip (10) and slide the accessory
onto the handle (2).
• Toremove an accessory, press the accessory			16
clip (10) and remove the accessory.	B	2
To unwrap and extend the handle and
hose:
The handle and hose can be unwrapped
from the main appliance for extended reach
when cleaning. Grab the handle where the
arrows indicate and lift upwards. Unwrap
the handle and hose from the main
appliance. The hose can extend up to		11	16
approximately 4 feet (1.21m).
To place the handle and hose back onto the
main appliance, wrap the hose back
underneath and around the vac making sure
that the hose fits between the two “feet” of
the appliance. Align the handle with its
cradle and click back into place.
The handle (2) can be removed from the
hose allowing the accessories to be
connected directly to the hose cuff (16)
when desired.
To remove the handle:
• Unclip the handle (2) from the appliance.	C
• Rotate the locking ring (3) counterclockwiseto
release the clips.
• Pull the hose away from the handle (2).
• Fit the accessorydirectly tothe hose cuff(16).
To refit the handle:
• Remove the accessory from the hose.
• Push the hose into the handle (2). Rotate
locking ring (3) clockwise until it clicks into			12
place.
Fitting the accessory caddy (figure C)
When not in use, accessories can be stored
in the accessory caddy (12). The accessory
caddy can be removed if necessary.
• To install the accessory caddy (12) push it
onto the lugs on the body of the appliance
until it clicks into place. NOTE: Caddy only
fits on one side of the appliance.
• To remove the accessory caddy (12) grasp
either of the rounded sides and pull it away from the base of the appliance.

4