Black & Decker FHV1080 manual Troubleshooting, Maintenance, Battery Removal And Disposal, figure G

TROUBLESHOOTING
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the appliance.
• The charger is plugged into a working electrical outlet.
• The appliance was switched to the off position to charge. The battery will not be
charged with the switch in the “on” position.
• The filter is clogged. Pull the door latch and open the dust container door. Remove
the pre-filter and the fine filter. Brush any loose dust off the filters and wash them in
warm, soapy water. Make sure the filters are dry before placing back in the vacuum.
BATTERY REMOVAL AND DISPOSAL
This product uses nickel-cadmium (Ni-Cd) rechargeable and recyclable batteries.
When the batteries no longer hold a charge, they should be removed from the Vac and
recycled. They must not be incinerated or composited.
The batteries can be taken for disposal to a Black & Decker, Company-Owned or
Authorized Service Center. SomeTM		local retailers are also participating in a national
recycling program (see “RBRC	Seal”). Call your local retailer for details. If you bring
the batteries to a Black & Decker Company-Owned or Authorized Service Center, the
Center will arrange to recycle old batteries. Or, contact your local municipality for
proper disposal instructions in your city/town.
To remove the battery pack for disposal:
1.) First, before attempting to disassemble				19
the product, turn it on and leave it on until			G
the motor completely stops insuring a
complete discharge of the batteries.
2.) Invert the appliance to get access to the
screws that attach the base.
3.) Remove the four screws (19) shown in
(figure G)
4.) Remove the base.
5.) Disconnect the 3-pin connector.
6.) Place the battery in suitable packaging to
prevent a short circuit of the battery
terminals.
7.) Dispose of batteries as per recommended				19
guidelines.
MAINTENANCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the
vac; never immerse any part of the vac into a liquid.
WARNING: Make sure the vacuum is completely dry before
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
using it.
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service organizations, always using identical
replacement parts.

7