Fisher VPC-CG6 Charging the Battery Pack, Insert the battery pack in the battery charger

CHARGING THE BATTERY PACK

Please charge the supplied battery pack before using it.

1 Insert the battery pack in the battery charger.

hInsert it in the direction indicated by the [o] mark on the battery pack.

2 Connect the supplied power cord to the socket on the battery pack charger.

hInsert the connector straight and securely.

3 Plug the power plug into a power outlet (AC 100 V to 240 V).

hRecharging begins. h During recharge, the

CHARGE indicator is lit red. h The recharge time is

approx. 90 minutes.

4 When the CHARGE indicator turns off, unplug the power cord from the power outlet, and remove the battery pack from the charger.

CHARGE indicator [o] mark

Battery pack Socket

To power outlet

Power cord

CHARGE indicator

HINT

Recharging when connected to the USB terminal (page 9 in the SANYO Software Pack INSTRUCTION MANUAL)

i The battery can be recharged while the camera is connected to a computer.

i Note, however, that the time it takes to recharge will differ depending on the camera’s operating condition.

i Connect the dedicated USB interface cable to the USB connector on your computer . Do not connect it to the USB connector on the monitor or the keyboard, or to the USB hub.

i When the surrounding temperature is high, depending on the camera’s operating condition and the battery pack temperature, in some cases the multi-indicator may slowly flash red and the battery pack cannot be charged.

i If the camera is not going to be used for an extended period of time, please disconnect the dedicated USB interface cable from the camera.

21English