You may wish to add to the length of the fence by attaching an extra piece of wood. Convenient holes are provided in the fence for this purpose, and also for attaching an extension guide (optional accessory).
II
NOTE :
When planing, move the tool with the edge fence flush with the side of the workpiece. Otherwise uneven planing may result.
Max. shiplapping depth is 9 mm ( 1 1/32").
Chamfering
To make a cut as shown a t the right, align the "V" groove in the front base with the edge of the workpiece and plane it as shown in the figure (A).
MA1NTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
The tool will stop when the carbon brushes wear to a certain length. When this occurs, both carbon brushes should be replaced.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and replacement, any other maintenance of adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
9