Makita 2004 instruction manual HOW T O USE the Sharpening Holder

Page 10

0To replace carbon brushes, use the (-1minus screwdriver equipped to remove the holder cap on the motor housing. Then replace the brush.

HOW T O USE THE SHARPENING HOLDER

 

0 First, loosen the 2 wing nuts on the holder

Wing nut

and insert blades Aand B as in figure a t right,

so that they contact side C and D.

-w

Then tighten wing nuts.

 

0Immerse dressing stone in water .Jr 2 or 3 minutes before sharpening. Iiold the holder so that blades both contact the dressing stone for simultaneous sharpening a t the same angle.

I

I O

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 132mm 5%MODEL Before Connecting Your Tool To a Power Source PRELlMlNARY I NSTRUCTlONS Socket wrench HOW to USE Page Page Lever to lock drum Press Maintenance HOW T O USE the Sharpening Holder 731013-7 132mm5% Planer Jointer Page LkM 220 24?c&k-*ud
Top Page Image Contents