PRELlMlNARY I NSTRUCTlONS

Your electric tool i s precision built and manufactured to satisfy the highest standards. For maximum performance, long tool life, and your safety, follow these instructions carefully.

VOLTAGE WARNING: Before connecting the tool t o a power source (receptacle, outlet, etc.) be sure the voltage supplied i s the same as that specified on the nameplate of the tool. A power source

with voltage greater than that specified for t h e tool can result in SERIOUS INJURY t o the user - as well as damage to the tool. I f in doubt, DO NOT PLUG IN THE TOOL. Using a power source with voltage less than the nameplate rating i s harmful to the motor.

For all grounded tools with American type plug.

GROUNDING INSTRUCTIONS: This tool should be grounded while in use t o protect t h e operator from electric shock. The tool is equipped with an approved three-conductor cord and threeprong grounding-type plug t o fit the proper grounding-type receptacle. The green (or green and yellow) conductor in the cord i s the grounding wire. Never connect the green (or green and yellow) wire t o a live terminal. I f your unit i s for use on less than 150 volts, it has a plug that looks like Fig. "A".

It i t i s for ure on 150-250volts, i t has a plug that looks like Fig. "D".

An adapter, Fig. "B" and " C ' is available for connecting Fig. " A ' plugs t o two-prong receptacles, (see Note). The green-colored rigid ear, lug, etc., extending from the adapter must be connected to a permanent ground such as to properly grounded outlet box. No adapter i s available for Fig. "D" plugs.

Grounding Blade

FIG. D

Grounding Blade

Cover' of Grounded Outlet Box	\

NOTE: THE GROUNDING ADAP-

TER IS PROHIBITED IN CANADA

PER CANADIAN ELECTRICAL

CODE-PART 1. THEREFORE, THE

INSTRUCTIONS FOR ITS USE ARE

NOT APPLICABLE IN CANADA.

EXTENSION CORDS: Use only three-wire extension cords which have three-prong grounding-type

plugs and three-pole receptacles which accept the tool's plug. Replace or repair damaged or worn :ord immediately.