2
Safety precautions
The ventilation
holesat the bottom
Carpet
Donot let the machine share one receptacle with other
electricappliances. If the plugging into the receptacle
is loose, do not use the plug any more.
Donot wash water-proof laundries like
theraincoat, bike covers etc. to avoid
abnormalvibrations in spinning.
Keepthe pin of the power plug clean, if the power plug is polluted with dust, please wipe with
drycloth carefully.
Donot bend ,extend, twist, bind by force. Do not press or nip it with weight.
If the power cord or the power plug is bad, to avoid risk it is required to have it replaced by
thetechnicians of our special shop or ourcustomer care agent.
Donot put the machine at damp place like
thebathroom. Never wash it with water. Do
notput wet laundries on the control panel.
Donot use water hotter than 50 .
Incase the washing machine is installed on ground with
carpet,do not block the ventilation hole with carpet.
Pleaseplug the power plug on special
receptacle.Be sure to use three-pins
powerreceptacle. Ensure that the earthing
prongof the power receptacle is earthed
reliably.Useleakage protector if possible.
Thewashing machinemust be positioned so that
the plug is accessible. Be sure to pull the plug off
andclose the water faucet in following cases:
powerfailure, delivering the machine, setting the
machineidle or cleaning the machine. Do not plug
orpull the power plug with wet hand.
Disposal after washing
Afterusing, please clean the lint and foreign materials of the lint filter etc. in time.
Otherwiseit may influence your using the machine.
Pleasefirst pull off the power plug from the receptacle before cleaning.
Cleanthe detergent box and set it on
thecontrol panel seat.
1.Themethod of dismantle: Push it up aslant and gently.
2.Themethod of install : install it upwards and aslant
andpush it in .
Thefilter screen of the water inlet valve is likely to be
blocked by foreign materials and influence the water
inlet.
Pleaseclean it with brush every two months.
Ifthe cabinet is dirty, wipe it with wet cloth
Donot flush it directly with water.
Wipeit with neutral detergent.
Donot wipe it with thinner, petrol, alcohol etc.
Lintfilter:
Thelint filter must be used during washing.
Itmust be cleaned in time after each using.
Figure1 Figure2
Down
Dismantle
Install
Theback cover of lint filter
Install
Dismantle
Down
Up
Up
Thefrontcover of lint filter
1.Pushdown the spring piece of the top lint filter
tomake the claws out of the filter cover, and then
pullout the lint filter to get it down. figure1
2.Pullthe back of the lint filter, and then you can
getdown it off the front cover of the lint filter. figure2
3.Sweepthe rubbish in the lint filter.
4.Putthe back of the lint filter into the front cover .
5.Putthe lint filter into filter cover, and make it
tight.
6.Makesure the lint filter well installed, or it can
influenceyour use.
1.Afterwashing, close the water faucet. (If needed, you can dismantle the water inlet hose).
5.Wipeoff the water drops on the surface of the machine and inside the tub. Open the top lid for some time
(about1 hour), then close the top lid.
4.Hangup the power cord and drain hose.
3.Besure to pull off the power plug before maintenance.
2.Donot store water in the washing machine for a long period. Drain the water completely after each using.
Thinner
Petrol
Alcohol
Dismantle Install