English
SPECIFICATIONS
Voltage (by areas)* | (110V, 115V, 120V, 127V, 220V, 230V, 240V) |
|
|
Power input* | 1450W |
|
|
850/min. | |
|
|
Weight (without cord) | 32 kg |
*Be sure to check the nameplate on this demolition hammer as it is subject to change by areas.
STANDARD ACCESSORIES |
| |
(1) | Hexagon Bar Wrench for M12 | 1 |
(2) | Hexagon Bar Wrench for M8 | 1 |
(3) | Hexagon Bar Wrench for M5 | 1 |
(4) | Side Handle | 1 |
(5) | Bolt | 4 |
(6) | Spring Lock Washer | 4 |
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
1. Bull point
Overall length: 520 mm
2. Cold chisel
and drainage work, interior jobs, harbor facilities and other civil engineering work.
PRIOR TO OPERATION
1.Power source
Ensure that the power source to be utilized conforms to the power requirements specified on the nameplate of this demolition hammer.
2.Power switch
Ensure that the power switch is in the OFF position. If the plug is connected to a receptacle while the power switch is in the ON position, this demolition hammer will start operating immediately, inviting serious accident.
3.Extension cord
When the work area is remote from the power source, use an extension cord of sufficient thickness and rated capacity. The extension cord should be kept as short as practicable.
4.Mounting an accessory, such as a bull point, a cutter, etc.
3. Scoop
4. Cutter
Overall length: 520 mm
Overall length: 546 mm
Overall length: 520 mm
Width: | 75 mm |
(1)With the retainer directed backward, insert the accessory shank point into the hole on the front cover. (Fig. 1)
(2)Swing the retainer back into place so that it engages the accessory shank point and prevents the accessory, such as a bull point, a cutter, etc. from
coming all the way out of front cover. (Fig. 2)
NOTE
Use a manual hammer to open/close the retainer, as it is too heavy to move by hand.
When removing the accessory, such as a bull point, a cutter, etc., follow the above procedure in reverse order.
5.Always hold the body handle and side handle of this demolition hammer firmly.
Otherwise the counterforce produced may result in inaccurate and even dangerous operation.
5. Hammer grease 500 g (in a can)
Optional accessories are subject to change without notice.
APPLICATIONS
This demolition hammer should be applied to breaking concrete, chipping off concrete, grooving, bar cutting and driving piles in installation of piping and wiring, sanitary facility installation, machinery installation, water supply
OPERATION
1.Pull the trigger switch after applying the tip of the bit to the crushing position.
In some cases, it is necessary to punch the tip of the bit against the crushing position forcibly in order to begin the striking stroke.
This is not due to malfunction of the power tool. It means that the safe guard mechanism against
3