Makita HM1214C dimensions Wiring diagram, Fig. D-2

Page 20

P 20/ 20

Wiring diagram

Fig. D-2

wiring on Controller Cover

Controller

Cover

Switch

Terminal

Sponge

Do not protrude Terminals from the edge of Controller cover when connecting them to Switch.

Correct Wrong

Put Controller’s Lead wires for connecting to Switch into the slit of Sponge.

Pay attention not to pinch the Lead wires with the edge of Controller or Controller cover (designated with hatching).

Cut the Power supply cord as illustrated below.

approx. 30mm

Fig. D-3

Wiring of Carbon Brush’s Pig Tail
Correct	Wrong

Brim of Brush	Brim side
Brim of Brush
Holder Unit

Pig Tails

Root

Spiral Spring, correctly pressing Carbon Brush

Brim of Brush Brim side

Pig Tail Spiral spring,holder unit pinching Pig tail

	Pig Tail’s	Pig Tail
	Root	Pig Tail
	Root

Carbon	Carbon
Brush	Brush
Rear Cover Side	Rear Cover Side

Pig tail’s Root on the brim side of Spiral spring does not pinch Pig tail by mistake when assembling.

Pig Tail’s Root on the Rear cover side Spiral spring easily pinches Pig tail by mistake when assembling.

Image 20

Contents Standard equipment SpecificationOptional accessories Tool holder section RepairTool holder section Hammer section Gear and Crank sectionBarrel and AVT mechanism Cylinder section Approx g Makita grease N.No.1DISASSEMBLY/ASSEMBLY Chuck sectionBarrel section AssemblingRepair DISASSEMBLY/ASSEMBLY 3-2. Barrel section Ring Fluoride ring 28 the worn one Before CorrectionCorrection After Correction CorrectedTool holder section Bearing box section, Piston, Crank section Disconnection of the Contact of Carbon brush with CommutatorBearing box section, Crank housing section Filter case Filter case coverHousing DISASSEMBLY/ASSEMBLY Wrench Repair DISASSEMBLY/ASSEMBLY 3-5. Motor section Electrical parts in Handle section LeafSpring Pay attention not to lose Leaf spring in this stepFastening torque FasteningTorque 30 40 N.mMaintenance Program Circuit diagram Controller Terminal BlockWiring diagram Fig. D-2