FIRE OR EXPLOSION hazard.
D Do not install or place unit on, over, or near combustible surfaces.
DDo not install unit near flammables.
DDo not overload building wiring − be sure power supply system is properly sized, rated, and protected to handle this unit.
FALLING UNIT can cause injury.
DUse lifting eye to lift unit only, NOT running gear, gas cylinders, or any other accessories.
DUse equipment of adequate capacity to lift and support unit.
DIf using lift forks to move unit, be sure forks are long enough to extend beyond opposite side of unit.
MOVING PARTS can cause injury.
D Keep away from moving parts such as fans.
D Keep all doors, panels, covers, and guards closed and securely in place.
DHave only qualified persons remove doors, panels, covers, or guards for maintenance as necessary.
DReinstall doors, panels, covers, or guards when maintenance is finished and before reconnecting input power.
READ INSTRUCTIONS.
D Read Owner’s Manual before using or servic- ing unit.
DUse only genuine replacement parts from the manufacturer.
OVERUSE can cause OVERHEATING
DAllow cooling period; follow rated duty cycle.
DReduce current or reduce duty cycle before starting to weld again.
DDo not block or filter airflow to unit.
FLYING SPARKS can cause injury.
D Wear a face shield to protect eyes and face.
D Shape tungsten electrode only on grinder with proper guards in a safe location wearing proper face, hand, and body protection.
DSparks can cause fires — keep flammables away.
STATIC (ESD) can damage PC boards.
DPut on grounded wrist strap BEFORE handling
boards or parts.
D Use proper
MOVING PARTS can cause injury.
DKeep away from moving parts.
DKeep away from pinch points such as drive rolls.
WELDING WIRE can cause injury.
DDo not press gun trigger until instructed to do so.
DDo not point gun toward any part of the body, other people, or any metal when threading welding wire.
H.F. RADIATION can cause interference.
D
DHave only qualified persons familiar with electronic equipment perform this installation.
DThe user is responsible for having a qualified electrician prompt- ly correct any interference problem resulting from the installa- tion.
DIf notified by the FCC about interference, stop using the equipment at once.
DHave the installation regularly checked and maintained.
DKeep
ARC WELDING can cause interference.
DElectromagnetic energy can interfere with sensitive electronic equipment such as computers and
DBe sure all equipment in the welding area is electromagnetically compatible.
DTo reduce possible interference, keep weld cables as short as possible, close together, and down low, such as on the floor.
DLocate welding operation 100 meters from any sensitive elec- tronic equipment.
DBe sure this welding machine is installed and grounded according to this manual.
DIf interference still occurs, the user must take extra measures such as moving the welding machine, using shielded cables, using line filters, or shielding the work area.