Miller Electric APT-1000 manual Installing Torch In Standard Power Source

Page 9

3-2. Installing Torch

WARNING

READ SAFETY BLOCK at start of Section 3 before proceeding.

A. Installing Torch In Standard Power Source

Turn Off power source, and disconnect input power plug. Re- move wrapper.

1 2 3 4

S-137 691

6

7

3

5

1

3

4

2

1Torch Cable

2Front Panel Opening

3Pilot Arc/Shield Cup Detector Lead 1

4Shield Cup Detector Lead 2

5Torch Switch Leads 3 and 4

Route cable and leads through front panel opening.

6Terminal Strip 1T

7Connection Label

Connect cable to air/torch (–) out- put connector which is not visible in Figure 3-2, but is located behind terminal strip 1T.

Refer to label and connect leads as shown.

Install wrapper.

8Work Cable (Supplied With Power Source)

8

5

4

Tools Needed:

5/8 in

1/4 in

ST-128 701-C

Figure 3-2. Installing Torch In Standard Power Source

OM-1572 Page 3

Image 9
Contents OM-1572A ProcessesDescription From Miller to You Plasma ARC Cutting Safety Precautions Plasma ARC can cause injury Fumes and Gases can be hazardous to your healthFlying Sparks and HOT Metal can cause injury Cylinders can explode if damagedEMF Information Table of ContentsPage Cutting Torch Safety InformationElectric Shock can kill Moving Parts can injureInstallation Duty CycleConsumables And Parts Supplied With Torch Installing Torch Operating the Torch Or Operation Remove spatter can damage torchWithout TIP or Electrode can damage TorchRoutine Maintenance Maintenance & TroubleshootingMonths Each UseReco Mmended VAL UES or Operat IO N Overtightening will strip threadsCutting Trouble Troubleshooting126 Parts ListPage Page Page Support ServiceMiller Electric Mfg. Co Owner’s Record