Miller Electric APT-1000 Installation, Duty Cycle, Consumables And Parts Supplied With Torch

Page 8

2-1. Duty Cycle

CAUTION

EXCEEDING DUTY CYCLE RATINGS will damage power source and torch.

 

• Do not exceed indicated duty cycles.

warn7.1* 2/92

Duty cycle is how long the torch and power source can operate within a ten minute period without causing overheating or damage. This torch is rated at 60% duty cycle when operated at 10 amperes, allowing cutting 6 minutes out of 10. If the cutting amperes decrease, the duty cycle increases.

SECTION 3 – INSTALLATION

WARNING

ELECTRIC SHOCK can kill.

• Do not touch live electrical parts.

• Turn Off power source, and disconnect input power before installing torch.

swarn3.1* 2/93

3-1. Consumables And Parts Supplied With Torch

Torch is shipped fully assembled and ready to install onto power source.

1

3

2

4

The following consumables are supplied with torch:

1Shield Cup

2Electrode

3Tip

4Wrench

Use supplied wrench to change tips and electrodes (see Section 5-2).

ST-800 225

Figure 3-1. Consumables And Parts Supplied With Torch

OM-1572 Page 2

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Description OM-1572AProcesses From Miller to You Plasma ARC Cutting Safety Precautions Fumes and Gases can be hazardous to your health Plasma ARC can cause injuryFlying Sparks and HOT Metal can cause injury Cylinders can explode if damagedTable of Contents EMF InformationPage Safety Information Cutting TorchElectric Shock can kill Moving Parts can injureConsumables And Parts Supplied With Torch InstallationDuty Cycle Installing Torch Operating the Torch Remove spatter can damage torch Or OperationWithout TIP or Electrode can damage TorchMaintenance & Troubleshooting Routine MaintenanceMonths Each UseOvertightening will strip threads Reco Mmended VAL UES or Operat IO NTroubleshooting Cutting TroubleParts List 126Page Page Page Service SupportOwner’s Record Miller Electric Mfg. Co
Top Page Image Contents